توضیحات
خلاصه
شــمع هــاي درجــا بطــور گســترده بــراي پــي پــل هــا وديگــر ســازه هــاي مهــم مــورد اســتفاده مــي گيرد.شــمع هــاي درجــا بــه منظــور پايــدار كــردن شـــيرواني هـــاي ســـنگي نيـــز مـــورد اســـتفاده مـــي گيرد.بارهـــاي اصـــلي وارده بـــر شـــمع هـــاي درجـــا عبارتنـــد از:بـــار هـــاي عمـــودي بارهـــاي بـــالا زننـــده (Uplift) وبارهـــاي جـــانبي .اگرچـــه بـــراي تحليـــل وطراحـــي شـــمع هـــاي درجـــا بـــويژه بـــراي بـــار جـــانبي روش هـــاي زيـــادي وجـــود دارد امـــا پيشـــرفت ايـــن روش هـــا بـــدون در نظـــر گـــرفتن نتـــايج ازمايشـــگاهي صـــورت گرفتـــه اســـت .مقايســـه نتـــايج ازمايشـــگاهي وبعضـــي از روش هـــاي طراحـــي نشـــان از غيـــر قابـــل اطمينـــان بـــودن ايـــن روش هـــا دارد.همـــواره نيـــاز بـــه يـــك روش طراحـــي منطقـــي بـــراي شـــمع هـــاي درجـــا در ســـنگ وجـــود داشـــته اســت. در ايــن مقالــه تقريبــا تمــام روش هــاي اصــلي تحليــل شــمع هــاي درجــا تحــت بارجــانبي در ســنگ بررســي شــده اســت .ودر اخــر هــم بــه خــاطر اهميت روش p-yيكي از روش هاي بدست آوردن منحني براساس نتايج ازمايشگاهي بررسي شده است.
مقدمه
شمع هاي درجا بطور گسترده براي پي پل ها وديگر سازه هاي مهم مورد استفاده مي گيرد.شمع هاي درجا به منظور پايدار كردن شيرواني هاي سنگي نيز مورد استفاده مي گيرد.بارهاي اصلي وارده بر شمع هاي درجا عبارتند از:بار هاي عمودي بارهاي بالا زننده وبارهاي جانبي .براي شمع ها تحت بار عمودي به ويژه براي تعيين مقدار برش در جداره تلاش هاي زيادي صورت گرفته اما براي شمع هاي درجا تحت بار جانبي يك روش منطقي براي تحليل وطراحي وجود ندارد. در عمل براي طراحي شمع هاي درجا در سنگ از روش هاي طراحي شمع ها در خاك استفاده مي كنند.اين عمل باعث بيش از حد لازم طراحي شدن طول شمع مي شود. در اين مقاله منظور از شمع شمع هاي بتني اجرا شده در سنگ است .گرچه براي طراحي شمع ها تحت بار جانبي روش هاي زيادي وجود دارد كه عبارتند از: Careter and Kulhawy(1992) ،Reese(1997) ،Zhang et al(2000) و Gabr .كه اين روش ها بدون در نظر گرفتن نتايج ازمايشگاهي پيشرفت داده شدند كه دو روش اول توسط بعضي از محققين مورد ارزيابي قرارگرفت كه نتيجه گرفتند اين روش ها غير محافظه كارانه است.روش Zhangبه خاطر پيچدگي نتوانست مورد ارزيابي قرارگيرد. همچنين فرض رفتار الاستيك كاملاً پلاستيك براي توده سنگ مانع استفاده گسترده از اين روش شد.روش p-yبه طورگسترده وموفقيت آميز براي تحليل شمع ها تحت بارجانبي در خاك در سال هاي اخيرمورداستفاده قرار گرفته است .اساس اين روش حل عددي مدل وينكلراست. اين اعتفاد وجود دارد كه روش p-yبهترين روش براي تحليل شمع هاي درجا درسنگ تحت بار جانبي است به شرط اينكه منحني p-yهاي درست ومنطقي براي توده ي سنگ داشته باشيم.
ABSTRACT
Inside locks are used extensively for bridge bridges and other important structures. Inside casts are used to stabilize the stone slopes. The main bays applied to the inverted piles are: vertical loads of uplifting loads (Uplift) and lateral forces. Although there are many methods for analyzing and designing in situ piles, especially for lateral loads, but the progress of these methods is unmatched Experimental results have been taken. Comparison of laboratory results and some of the design methods show the unreliability of these methods. There has always been a need for a logical design method for in situ stone piles. In this paper, almost all of the main methods of analysis of in situ piles under a logarithm in the rock are investigated. Finally, due to the importance of the p-y method, one of the methods for obtaining a curve based on laboratory results has been investigated.
INTRODUCTION
Inside locks are used extensively for bridge bridges and other important structures. Inside casts are used to stabilize the stone slopes. The main bays applied to the inverted piles are: vertical loads of uplifting loads Lateral forces. For piles under vertical load, special efforts have been made to determine the amount of cutting in the wall, but there is no logical method for analysis and analysis for lateral load on the pile. In practice, the design of piles in the stone used in the rock uses the design of piles in the soil. This operation causes the design of the length of the candle too much. In this article, there are a number of ways to construct piles under side load, such as Careter and Kulhawy (1992), Reese (1997), Zhang et al (2000) And Gabr. These methods, without considering the lab results, were improved, with the first two methods being evaluated by some researchers who concluded that these methods are not conservative. Zhang’s method was not evaluated due to its complexity. Also, the assumption of completely plastic elastic behavior for the mass of stone has prevented the widespread use of this method. The p-y method has been widely and successfully used for the analysis of piles under load in the soil in recent years. This method is based on numerical solution of the Vincral model. It is believed that the p-y method is the best method for the analysis of pile in situ under load, provided that the curve of p-ys is correct and logical for the rock mass.
Year: 2011
Publisher : Sixth National Congress on Civil Engineering
By : Nader Hatef , Alireza Yaseri
File Information: English Language/ 8 Page / size: 478 KB
Only site members can download free of charge after registering and adding to the cart
سال : 1390
ناشر : ششمین کنـگره ملی مهنـدسی عمـران
کاری از : نادرهاتف ، عليرضاياسري
اطلاعات فایل : زبان فارسی / 8 صفحه / حجم : KB 478
نقد و بررسیها
هنوز بررسیای ثبت نشده است.