توضیحات
چکیده
در پژوهش حاضر، اثر افزودني هاي كربن و تيتانيوم بر ساختار آلياژهاي مغناطيسي نانو كامپوزيت مورد بررسيNd9/4Pr0/6FebalCo6B6Ga0/5TixCx (x=0,1/5,3,4/5,6)نئوديميوم_ آهن_ بور با تركيب قرار گرفته است. براي توليد اين آلياژها از يكي از روشهاي متداول انجماد سريع معروف به “چرخ مذاب” با سرعت ثابت چرخش چرخ مسي برابر 40 m/sاستفاده شده است. نوارهاي حاصل از انجماد سريع از طريق آناليز پراش پرتو ايكس (XRD) وآناليز حرارتي (DSC) ارزيابي شدند. نتايج آزمايشات مذكور نشان مي دهد افزودني هاي كربن و تيتانيوم تمايل به تشكيل فاز شيشه اي را افزايش مي دهند. همچنين دماي تبلورفاز مذكور با افزايش مقدار Tiو Cد 5/4تا رصد اتمي افزايش و پس از آن كاهش مييابد.
مقدمه
نانوكامپوزيت هاي مغناطيسي نئوديميوم _ آهن _ بور داراي ريزساختاري متشكل از فاز نـرم مغناطيسـي Fe3Bو يا α– Feويك فاز سخت مغناطيسي Nd2 Fe14Bمي باشند. در اين مواد فاز نـرم مغناطيسـي داراي آهنربايش ذاتي بالا و فاز سخت مغناطيسي داراي ثابت ناهمسان گردي بالا مي باشد، بنابراين در اين نسل از آهن رباهاي دائم بر اثر افزايش پسماند ناشي از پديده كوپلاژ تبادلي بين دو فـاز سـخت ونـرم مغناطيسـي خواص مغناطيسي مناسبي با مقادير كمتري از عناصر نـادر خـاكي در مقايسـه بـا آلياژهـاي تـك فـاز قابـل حصول مي باشد ودرنتيجه هزينه توليد كاهش مي يابد. مطالعات Knellerو Hawigنشان داد كه در ساختاري متشكل از فازهاي نرم و سخت مغناطيسي، پديده كوپلاژ تبادلي در صورتي كه اندازه هـر دو فاز سخت و نرم در رنج دو برابر عرض ديواره سامانه فاز سخت (كمتر از 10nmبـراي اغلـب فازهـاي سخت) باشد، رخ مي دهند. بنابراين بسيار مهم است كه يك ريز ساختار يكنواخت با دانه هـاي ريـز بـراي رخداد پديده كوپلاژ تبادلي توليد گردد. ريز ساختار نانوكامپوزيت ها به نرخ سردشدن مذاب، فراينـد آنيل و همچنين تركيب آلياژ بستگي دارد. درسالهاي اخير تحقيقات فراواني براي افزايش خواص مغناطيسي با كمـك عناصـر افزودنـي انجـام گرفتـه است. نتايج بدست آمده نشان مي دهد خواص مغناطيسي نانوكامپوزيت ها با بهسازي ريز ساختار بـه ويـژه ريزساختار فاز α– Feبا و يا افزايش خواص مغناطيسي فازهـاي اصـلي افـزايش مـي يابـد. بـراي مثـال Nb اندازه دانـه α– Feرا كـاهش و وادارنـدگي را افـزايش مـي دهـد.كبالـت، اشـباع آهنربـايش آهنرباهـاي نانوكامپوزيت Nd2 Fe14B / α – Feرا افزايش مـي دهـد. در پـژوهش حاضـرتاثير اثركـربن و تيتـانيوم بـر نوارهاي انجماد سريع شده مورد بررسي قرار مي گيرد.
ABSTRACT
In this work the effects of Ti and C additions on the structure of Nd-Fe-B nanocomposite permanent magnetic alloys with nominal composition of Nd9.4Pr0.6FebalCo6B6Ga0.5TixCx (x=0, 1.5, 3, 4.5 and 6) have been investigated .One of the most predominant methods called “melt spinning” by constant wheel speed of v=40m/s was used to produce these alloys. As-spun ribbons were examined by using X-ray diffractometer (XRD) with Cu-kα radiation and differential scanning calorimetry (DSC). The results show that Ti and C additions enhance the glass forming ability and also increase crystallization temperature up to 4/5% of Ti and C and then it reduces.. .
INTRODUCTION
Magnetic nanocomposites have a microstructure consisting of a soft magnetic phase Fe3B or α-Fe and a Nd2 Fe14B hard magnetic phase. In this material, the soft magnetic phase has a high magnetism and a solid magnetic phase with a high anisotropy constant. Therefore, in this generation of permanent magnetism, due to the increase in the amount of waste resulting from the exchangeable coplanar phenomenon between the two phases and the magnetic field, the magnetic properties are appropriate with the values Fewer rare earth elements can be obtained in comparison with single-phase alloys, and hence the cost of production decreases. Studies by Kneller and Hawig showed that in a structure consisting of soft and hard magnetic phases, the exchangeable collapse phenomenon occurs when the size of both hard and soft phases occurs at twice the width of the wall of the hard phase system (less than 10 nm for most of the hard phases) . Therefore, it is very important to produce a uniform microstructure with fine grains for the occurrence of an exchangeable coplanar phenomenon. The microstructure of the nanocomposites depends on the rate of melt cooling, the annealing process and the alloy composition. In recent years, numerous studies have been done to increase the magnetic properties with the help of additive elements. The results show that the magnetic properties of nanocomposites increase with the improvement of the microstructure, in particular, the microstructure of the α-Fe phase, or the increase of the magnetic properties of the main phases. For example, Nb reduces the grain size of α-Fe and increases its inducibility. Cobalt increases the magnesium saturation of Nd2 Fe14B / α-Fe nanocomposite magnets. In the present study, the effects of carbon and titanium on fast freezing films are investigated.
Year: 2007
Publisher : 11th National Congress of metallurgy of Iran
By : Mahsa Esfahani. Reza Gholami Pour. Shamseddin Mirdamadi Ali Mohammadi
File Information: persian Language/ 10 Page / size: 127 KB
سال : 1386
ناشر : يازدهمين كنگره ملي مهندسين متالورژی ايران
کاری از : مهسا اصفهاني . رضا غلامي پور . شمس الدين ميردامادي . علي محمدي
اطلاعات فایل : زبان فارسی / 10 صفحه / حجم : KB 127
نقد و بررسیها
هنوز بررسیای ثبت نشده است.