توضیحات
چکیده
اكتيويته و ضريب اكتيويته اجزاي سيستم دوتايي Al-Mgمذاب محتوي 1/ 07تا 12 /0درصد اتمي منيزیم با استفاده از اندازه گيري نيروي محركه الكتريكي يك سلول الكتروشيميايي غلظتي منيزيم Mg (l)∣MgCl2-CaCl2 (eutectic melt,l)∣Mg (in Al,l) در محدوده 973الي ،1073Kتعيين شد. براي اين آلياژها كه در صنعت بسيار مورد استفاده هستند اطلاعات ترموديناميكي بسيار متناقضي در مراجع موجود است. مطالعه حاضر نشان داد كه در اين آلياژها منيزيم انحراف منفي از رفتار محلول هاي ايده آل از خود نشان ميدهد. آلياژهاي محتوي تقريبا 6تا درصد اتمي منيزيم از قانون هنري تبعيت كرده و ضريب هنري منيزيم در دماهاي 1023 ،973و 1073Kبه ترتيب برابر با ، 47/0و 53/0 52/0محاسبه شد. مقادير ضريب تاثير درجه يك واگنر منيزيم بر منيزيم در مذاب آلومينيم در محلول هاي رقيق در دماهاي 1023 ،973و 1073K به ترتيب برابر با ، 26/0 25/0و 22/0 محاسبه شد.
مقدمه
آلياژهاي آلومينيم-منيزيم به خاطر سبكي وزن و خواص مكانيكي و مقاومت به خوردگي عالي در صنعت بسيار مورد استفاده قرار مي گيرند. لذا اطلاع از خواص ترموديناميكي اين آلياژها از نظر علمي و عملي بسيار حائز اهميت است. مطالعات متعددي در اين خصوص توسط محققين مختلف انجام شده، اما اختلافات قابل توجهي در نتايج ارائه شده توسط آنها مشاهده ميگردد. در اين خصوص، اطلاعات موجود براي آلياژهاي آلومينيم با درصد منيزيم پايين، كم و در عين حال داراي تفاوت هاي چشمگيري است. بنابراين انجام مطالعات در اين خصوص ضروري به نظرمیرسد. Pogodayev و Lukashenko از دو روش emfو فشار بخار (روش گاز حامل) جهت بررسي ترموديناميكي آلياژهاي مذاب Mg-Alاستفاده كردند. بر پايه مطالعات آنها مشخص شد كه روش emfنتايج بسيار دقيقتري را براي مقدار aMgحاصل ميكند. روش فشار بخار، براي aMgانحراف مثبت از رفتار رائولتي (محلول ايده آل) را نشان ميداد كه برخلاف واقعيت هاي موجود در مراجع بود. آنها دليل اين امر را، فعاليت سطحي بالاي منيزيم و تجمع آن در لايه هاي سطحي مذاب عنوان كردند. در واقع تنها لايه اي از مذاب، كه نسبت به تركيب شيميايي كل مذاب تفاوت زيادي داشت، با بخار منيزيم موجود در بالاي آن به تعادل رسيده بود. Beltonو RaOنيز نسبت به صحت نتايج حاصل از روش فشار بخار ابراز ترديد كردند. در عين حال Tiwariاز يك سلول غلظتي الكتروشيميايي بر پايه الكتروليت مذاب جهت تعيين اكتيويته منيزيم در مذاب آلياژهاي Al-Mgاستفاده كرد.
ABSTRACT
Activation and activation coefficient of Al-Mg binary system components containing 0.17-0.12% magnesium atom by measuring the electric drive of an electrochemical cell Mg (l) | MgCl2-CaCl2 (eutectic melt, l) | Mg (in Al, l) was determined in the range of 973 ± 1073K. For these alloys, which are widely used in the industry, there is a highly contradictory thermodynamic information in existing references. The present study showed that in these alloys, magnesium exhibits a negative deviation from the behavior of ideal solutions. Alloys containing about 6% magnesium atomic percent were followed by artistic law, and magnesium artifact coefficients at 1023, 973 and 1073K, respectively, were calculated to be 0/47, 0/53/053, respectively. Magnitude Wagon Magnesium Magnesium Effect Coefficients in Aluminum Melt in Diluent Solutions at 1023, 973, and 1073K, respectively, were calculated to be 0.25, 0.26 and 0.22, respectively.
INTRODUCTION
Aluminum-magnesium alloys are widely used in industry because of its light weight, mechanical properties and excellent corrosion resistance. Therefore, it is very important to know the thermodynamic properties of these alloys scientifically and practically. Several studies have been conducted in this regard by various researchers, but significant differences are observed in the results presented by them. In this regard, the information available for aluminum alloys with low magnesium content is low and at the same time has a significant difference. Therefore, studies in this regard are necessary. Pogodayev and Lukashenko used two methods of emf and vapor pressure (gas carrier method) to study the thermodynamic properties of Mg-Al alloy melt. Based on their studies, it was found that the emf method yields far more accurate results for the amount of aMg. The steam pressure method, for aMg, showed a positive deviation from the rational behavior (ideal solution), which was contrary to the realities in the references. The reason for this was the high surface activity of magnesium and its accumulation in molten surface layers. In fact, only a layer of melt, which differed greatly from the total chemical composition of the melt, was equilibrium with the magnesium vapor found on top of it. Belton and RaO expressed doubts about the accuracy of the results obtained from the steam pressure method. Meanwhile Tiwari used an electrolytic electrolytic cell based on molten electrolyte to detect magnesium activity in Al-Mg alloy melt.
Year: 2007
Publisher : 11th National Congress of metallurgy of Iran
By : Gholamreza Karimi Aghdam, Mansour Soltanieh
File Information: persian Language/ 12 Page / size: 242 KB
سال : 1386
ناشر : يازدهمين كنگره ملي مهندسين متالورژی ايران
کاری از : غلامرضا كريمي اقدم ، منصور سلطانيه
اطلاعات فایل : زبان فارسی / 12 صفحه / حجم : KB 242
نقد و بررسیها
هنوز بررسیای ثبت نشده است.