توضیحات
چکیده
هدف از اين تحقيق بررسي اثر پارامتر سرعت خطي جريان آب بر كارايي سيستم الكترونيكي بر ايجاد رسوب در مبدل هاي حرارتي ميباشد.غلظت ونهاي آب مورد استفاده در اين آزمايش 1520ppm ميباشد كه با سرعتهاي m/s 0/8,0/5,0/2در درون لوله در جريان است. در مجموع دو سري تست يكبار بدون اعمال ميدان الكترومغناطيس و يكبار با اعمال ميدان الكترومغناطيس به مدت 40ساعت انجام شد.نتايج نشان ميدهد كه در كمترين سرعت ميزان كارايي سيستم الكترونيكي حداكثر است به گونه اي كه در سرعت %65 0/5m/s %، 59 0/2msو در %54 0/8m/sكاهش در مقاومت رسوب مشاهده ميشود.
مقدمه
زمانيكه آب در يك مبدل حرارتي حرارت ميبيند رسوب اتفاق مي افتد.انواع رسوبات بدست آمده بستگي به محتوي يونهاي درون آب دارد.يكي از معمولترين اين رسوبات در آب كربنات كلسيم است كه موضوع اين تحقيق ميباشد. ايجاد رسوبات در مبدل حرارتي دو مشكل را ايجاد ميكند . يكي كاهش كارايي مبدل حرارتي كه بستگي به هدايت حرارتي رسوبات دارد كه حتي يك لايه نازك از رسوب هم بازدهي مبدل حرارتي را بسيار پايين مي آورد . مشكل دوم تغييري است كه در قطر داخلي مبدل حرارتي به واسطه ايجاد رسوب ايجاد ميشود و سرعت خطي جريان آب را كاهش ميدهد. از اوايل قرن نوزدهم ، انجام تحقيقات مختلف توانست منجر به ايجاد روشهاي متعددي براي جلوگيري از ايجاد رسوب و هزينه هاي ناشي از آن شود.اين روشها را به طور خلاصه ميتوان چنين نام برد : 1استفاده از ممانعت كننده هاي شيميايي ( مانند تركيبات ارگانوفسفات) كه در مقادير كم ميتوانند ايجاد رسوب را به تاخير بيندازند. 2اسيد شويي 3مبدلهاي يوني 4واحدهاي عمليات الكتريكي آب 5استفاده از ميدانهاي فراصوتي 6استفاده از اشعه ماوراءبنفش 7عمليات مغناطيسي آب استفاده از ميدانهاي مغناطيسي به منظور جلوگيري از رسوب، از سالها پيش مورد توجه بوده است و شايد بتوان گفت عمري بيشتر از 50سال دارد. براي انجام اين مقصود دستگاههاي مختلف با اشكال گوناگون استفاده شده اند و در آنها جهتهاي جريان آب و ميدان مغناطيسي نسبت به هم وضعيت هاي متنوعي دارند و ميدان مغناطيسي توسط آهنرباي دائم ايجاد ميشود. اين تجهيزات در سالهاي اخير بسيار مباحث داغ و جنجال برانگيزي را ايجاد كرده اند . نمونه اي موفق از كاربرد اين سيستمها در سال 1988توسط Grimes Donalsonارائه گرديد كه درگزارشات Parsonsو همكارانش ذكر شده است.
ABSTRACT
The purpose of this study was to investigate the effect of the linear velocity flow parameter on the efficiency of the electronic system on sedimentation in heat exchangers. The water vapor concentration used in this experiment is 1520ppm, which at 0.08.0 m / s / 2 is inside the tube. In total, two sets of tests were performed once without applying electromagnetic field and once with the application of an electromagnetic field for 40 hours. The results show that at the lowest speed, the efficiency of the electronic system is maximum, at a rate of 65% / 5m / s% 59 0 / 2ms and a decrease of 0.58 m / s in the sediment resistance.
INTRODUCTION
Sedimentation occurs when the water is heated in a heat exchanger. The range of sediments obtained depends on the content of ions in the water. One of the most common sediments in calcium carbonate water is the subject of this research. Creating sediments in the heat exchanger creates two problems. One is the reduction of the efficiency of the heat exchanger, which depends on the thermal conductivity of the sediments, which even a thin layer of sedimentation lowers the efficiency of the heat exchanger. The second problem is the change that occurs in the inner diameter of the heat exchanger due to the formation of sediment and reduces the linear velocity of the water flow. From the beginning of the nineteenth century, conducting various researches has led to the creation of several methods to prevent sediment build-up and its costs. The following can be summarized as follows: 1. The use of chemical inhibitors (such as organophosphate compounds) In small amounts, they can delay sedimentation. 2 Acid washing 3 Ionic converters 4 Electric water units 5 Use of ultrasonic fields 6 Using ultraviolet radiation 7 Magnetic water use The use of magnetic fields to prevent sediment has been considered for many years, and it may be said that life is more than 50 years old. To do this, different devices are used in various shapes, in which the directions of the flow of water and the magnetic field are in different positions, and the magnetic field is created by a permanent magnet. In recent years, these equipment has created a lot of hot and controversial topics. A successful example of the use of these systems was presented by Grimes Donalson in 1988, which is mentioned in Parsons and colleagues’ reports.
Year: 2007
Publisher : 11th National Congress of metallurgy of Iran
By : Maryam Parvanehpour, Alireza Sabour Rooh Aghdam
File Information: persian Language/ 10 Page / size: 167 KB
سال : 1386
ناشر : يازدهمين كنگره ملي مهندسين متالورژی ايران
کاری از : مريم معنوي پور, عليرضا صبور روح اقدم
اطلاعات فایل : زبان فارسی / 10صفحه / حجم : KB 167
نقد و بررسیها
هنوز بررسیای ثبت نشده است.