توضیحات
چکیده
با توجه به تغييرات آيين نامه ها به مرور زمان، نياز است بررسي شود كه آيا ساختمانهاي بتني طراحي شده براساس آنها از نقطه نظر سطح عملكرد، معيارهاي پذيرش دستورالعمل بهسازي ايران را برآورده مي كنند يا نياز به مقاوم سازي دارند. در صورت نياز به مقاوم سازي آيا استفاده از مهاربند فولادي تاثيري در جهت بهبود رفتار سازه و كاهش تغييرمكان جانبي خواهد داشت. در اين تحقيق 24مدل ساختمان بتني 15،12،8،5طبقه كه هركدام شامل دو مدل 3و 4دهانه ميباشند در قالب سيستم قاب خمشي منظم با شكل پذيري متوسط و نيز به دو صورت مهار بندي دهانه هاي وسط ودهانه هاي كناري بر اساس استاندارد 2800ويرايش سوم طراحي شده و عملكرد مدلها قبل و بعد از مهاربندي بر اساس دستورالعمل بهسازي لرزه اي ايران مورد ارزيابي قرار گرفته است بررسيها نشان مي دهد كه در ساختمانهاي بتني عادي تعداد مفاصل كمتري نسبت به حالت مهاربندي شده تشكيل شده ولي مفاصل تشكيل شده از نوع مخربتري مي باشد. همچنين با افزايش تعداد طبقات درصد تشكيل مفاصل براي هر دو نوع ساختمان كاهش مي يابد و اين كاهش در ساختمانهاي 3 دهانه نمايانتر است .در كل مشاهده شد كه سازه هاي مهاربندي شده در مقايسه با حالت عادي چه از لحاظ تغيير مكان جانبي و چه از لحاظ ظرفيت برشي عملكرد بهتري از خود نشان ميدهند.
مقدمه
تاكنون روشهاي متفاوتي جهت مقاوم سازي ساختمانهاي موجود مورد استفاده قرار گرفته است. به منظور افزايش مقاومت لرزه اي سازه هاي قابي، اغلب مهاربندي فولادي يا ديوارهاي برشي مورد استفاده قرار مي گيرد. استفاده از ديوارهاي برشي در سازه هاي قابي بتن مسلح و مهاربندي هاي فولادي در سازه هاي قابي فولادي متداول است. با توجه به سهولت اجرا و هزينه ي نسبتا پايين مهاربندي فولادي، استفاده از اين سيستم در سازه هاي بتن مسلح مطرح مي شود، اما از عملكرد اين سيستم مقاوم سازي در سازه هاي بتن مسلح دانش بسيار اندكي در دست است. همچنين با تغيير نگرش دانشمندان از طراحي بر اساس نيرو به سمت طراحي بر مبناي رفتار، روش طراحي براساس عملكرد كه بر تحليل استاتيكي غيرخطي استوار است، مطرح شد كه تاكيد آن بر تغيير معيار طراحي مقاومت به عملكرد مي باشد و اساس كلي اين روش كنترل رفتار و تعقيب مكانيزم هاي خرابي در سازه تحت زلزله هاي با سطوح خطر متفاوت مي باشد.
ABSTRACT
With regard to the changes in the regulations over time, it is necessary to consider whether the concrete structures designed on the basis of their performance level, meet the criteria for accepting Iran’s recovery plan or need to be retrofitted. If reinforcement is required, the use of steel bracing will have an effect on improving the structural behavior and reducing lateral displacement. In this study, 24 concrete building models of 15, 12, 8, 5 floor, each containing two models of 3 and 4 openings, are in the form of a regular folding frame with a ductility moderate, as well as in the middle of the openings in the middle of the openings, according to the standard 2800 of the third edition. And the performance of the models before and after the bracing was evaluated based on the seismic recovery plan of Iran. Studies show that in normal concrete structures, the number of joints is less than that of the braced state, but the joints are of a more destructive type. Also, with increasing number of classes, the percentage of joints formation for both types of buildings decreases and this decrease is more pronounced in 3-span structures. In general, it was observed that the braced structures compared to the normal state either in terms of lateral displacement or in terms of Shear capacity shows better performance.
INTRODUCTION
So far different methods have been used to retrofit existing buildings. In order to increase the seismic resistance of framed structures, steel bracing or shear walls are often used. The use of shear walls in conventional reinforced concrete structures and steel bracing is common in steel framed structures. Due to the ease of implementation and the relatively low cost of steel bracing, the use of this system is presented in reinforced concrete structures, but there is little knowledge about the performance of this retrofitting system in RC structures. Also, by changing the attitude of scientists from design based on force to behavioral design, a design based on performance that is based on nonlinear static analysis is proposed, which emphasizes the change in the standard design of resistance to performance, and the general basis of this behavior control approach And the pursuit of fault mechanisms in the structure is different under earthquakes with different levels of risk.
Year: 2011
Publisher : Sixth National Congress on Civil Engineering
By : Wafa Murseli
File Information: persian Language/ 8 Page / size: 291 KB
Only site members can download free of charge after registering and adding to the cart
سال : 1390
ناشر : ششمین کنـگره ملی مهنـدسی عمـران
کاری از : وفا مرسلي
اطلاعات فایل : زبان فارسی / 8 صفحه / حجم : KB 291
نقد و بررسیها
هنوز بررسیای ثبت نشده است.