توضیحات
چکیده
در اين پژوهش فولاد زنگ نزن دو فازي AISI 329به جهت تعيين رفتار كار گرم آن، مورد آزمـايش كشش گرم قرار گرفته است. آزمايش ها در 8دما بين 850-1200°Cبا فواصل پنجـاه درجـه اي و در سه سرعت كرنش 0/001S-1و 0/04S-1و 0/15 S-1انجام شده است. در دو سرعت كرنش0/15S-1 و 0/04 S-1و دماهاي بين 950تا 1200درجه سانتي گراد، منحنـي هـاي تـنش-كـرنش ايـن فـولاد داراي شكل خاصي مي باشد كه اين امر به دليل شروع لغزش مرز فريت-آستنيت است. در دماهاي بالاي ° 1000 Cكار سختي ديده نمي شود، علت اين امر لغزش مرز فريت- آستنيت مي باشـد كـه مـانع اعمـال كرنش به دانه ها و ايجاد كارسختي مي شود. اين فولاد در سرعت هاي كـرنش كـم و در دماهـاي بـالاي °،1000 Cرفتار ابرمومسان و تا %400اضافه طول از خود نشان مي دهد.
مقدمه
فولاد هاي زنگ نزن دو فازي حاصل سيستم آلياژي Fe – Cr – Niهستند. ايـن فولادهـا حـاوي 17-30درصد كروم و 3-13درصد نيكل مي باشند و عناصر ديگري در طراحي هاي مختلـف بـه آن اضـافه مي شود. ايـن فولادهـا داراي سـاختار دوتـايي فريـت-آسـتنيت هـستند و داراي اسـتحكام و مقاومـت بـه خوردگي خوبي مي باشند. بسياري از محققين در مـورد ايـن فولادهـا رفتـار ابرمومـساني را گـزارش نموده اند. در اين پژوهش ها شرط رفتار ابرمومسان، ساختار دو فازي با دانه بندي ريز ذكر شده است. در غالب تحقيقات انجام شده، در مورد مكانيسم رفتار ابرمومسان و رفتار نش-كـرنش هـيچ صـحبتي بـه ميان نيامده است. در تحقيقي كه توسط سيرواستاوا و همكارانش انجام شـده اسـت در سـرعت هـاي كرنش كم (كمتر از0/04S-1 )نمودارهاي تنش-كرنش بدون هيچ كار سختي گزارش شده اند ولـي در مورد دليل آن بحث نشده است. در عين حال حققين، مكانيسم ابرمومساني را تبلور مجدد مداوم و يا لغزش مرزدانه بيان مي كنند. در اين تحقيق از يك ميلگـرد نـورد شـده بـا تركيـب شـيميايي %0/32 ،Ni: %5 ،C: %0/12 ،Cr: %21 : Ti: %0/73 ،Si: %0/55 ،Mnاستفاده شده است. ميلگرد اوليه به مدت يك ساعت در دماي 1000°C آنيل شده و سپس نمونه هاي كشش گرم با طول سنجه 40ميلي ليتر از آن تهيه گرديد،آزمايش كـشش گـرم همـدما در دماهـاي 1150 ،1100 ،1050 ،1000 ،950 ،900 ، 850و 1200درجـه سانتي گراد در سـه سـرعت كـرنش 0/001S-1و 0/04S-1و ،0/15 S-1توسـط دسـتگاه كـشش گـرم Zwickدر مجتمع فولاد آلياژي اصفهان انجام شد.
ABSTRACT
In this study, the AISI 329 dual-phase stainless steel has been tested for its hot work behavior. The experiments were carried out at 8 temperatures between 850-1200 ° C at 50 degrees and at three speeds of 0.001S-1 and 0.04S-1 and 0.15-S-1. At strain rates of 0.15 S-1 and 0.04 S-1 and temperatures between 950 and 1200 ° C, the stress-strain curves of this steel have a particular shape, which is due to the slippage of the frit-austenite boundary. At temperatures above 1000 ° C, hard work is not observed, due to the slippage of the ferrite-austenite boundary, which prevents the application of strain to seeds and the generation of hardiness. This steel is low in strain rates and at high temperatures, ° C, 1000 ° C, an over-monomane behavior and up to 400% long.
INTRODUCTION
Two-phase stainless steels are produced by the Fe-Cr-Ni alloy system. These steels contain 17-30% chromium and 3-13% nickel, and other elements are added in various designs. These steels have a dual ferrite-austenite structure with good corrosion resistance and strength. Many researchers have reported superhumanism about these steels. In these studies, the superconducting behavior condition is described, the two-phase structure with fine grain size is mentioned. In most studies, there has been no talk about the mechanism of supermensian behavior and the behavior of Nash-Strain. In a study conducted by Sierostawa and colleagues, strain-strain diagrams have been reported without difficulty at low strain rates (less than 0.4 S-1), but have not been discussed for reasons. At the same time, the truth is that the supermensian mechanism is characterized by repeated recrystallization or cross-slipping. In this research, a rolled mill with a chemical composition of 0.32%, Ni: 5%, C: 12.0%, Cr: 21% Ti: 0.73%, Si: 55.1%, Mn was used. . Annealed rod was annealed for 1 hour at 1000 ° C and then warm stretch samples with a length of 40 ml were prepared. Coarse stretching test at 1150, 1100, 1050, 1000, 950, 900, 850 and 1200 degrees centigrade Gradient at velocity velocity of 0.001S-1 and 0.04S-1, and 0.15-S-1 by Zwick warm stretching device in Isfahan Alloy Steel Complex.
Year: 2007
Publisher : 11th National Congress of metallurgy of Iran
By : Farrokh Taherkhani, Ahmad Rahimi, Jamshid Aghazadeh
File Information: persian Language/ 8 Page / size: 312 KB
سال : 1386
ناشر : يازدهمين كنگره ملي مهندسين متالورژی ايران
کاری از : فرخ طاهرخاني ، احمد رحيمي ، جمشيد آقازاده
اطلاعات فایل : زبان فارسی / 8 صفحه / حجم : KB 312
نقد و بررسیها
هنوز بررسیای ثبت نشده است.